MacDon M150 2008 Operator's Manual page 36

CAB FORWARD/ENGINE RUNNING/HEADER ENGAGED
(Scroll Through Display with CDM Switch or GSL Switch)
DISPLAY (Lower or Upper Line)
#####.# ENGINE HRS
#####.# HEADER HRS
##.# ACRES/HOUR
##.# HECTARES/HOUR
###.# SUB ACRES
###.# SUB HECTARES
###### TOTAL ACRES
###### TOTAL HECT
##.## REEL MPH
##.## REEL KPH
##.## REEL SENSOR
##.# DRAPER SPEED
#### KNIFE SPEED
#### KNIFE SENSOR
##.# HEADER HEIGHT
##.# HEADER SENSOR
##.# HEADER ANGLE
##.# HEADER SENSOR
##.# L FLOAT R ##.#
LOAD|■■■■■■■■■■■■
##.# VOLTS
SCROLL
(Lower Line)
NOTE: The load sensor is factory installed on M200 (optional for M150) to monitor knife/conditioner circuit
pressure. To monitor reel circuit pressure, relocate sensor as per Instruction 169031 which is available
through your dealer.
KNIFE SPD OVERLOAD
Form # 169017
OPERATOR'S STATION
DRAPER HEADER/INDEX SWITCH OFF
(If Metric)
(If Metric)
(If Metric)
(If Metric)
(If Sensor Disabled)
(If Sensor Disabled)
(If Sensor Disabled)
(If Sensor Disabled)
(Lower Line)
Total Engine Operating Time.
Total Header Operating Time.
Actual Cutting Rate In Acres (Hectares)/Hour.
Area Cut Since Last Reset.
Total Area Cut By Machine.
Reel Peripheral Speed.
Draper Speed (0.0-10.0).
Knife Speed In Strokes Per Minute.
Distance Setting (00.0-10.0) Between Cutterbar &
Ground.
Angle Setting (00.0-10.0). Header Relative To
Ground.
Left And Right Float Setting (0.0-9.9).
Bar Graph Representing Hydraulic Operating
Pressure. If sensor disabled, LOAD does not
display. See Note below.
Engine Electrical System Operating Voltage.
Displays Sub-Menu After 2-3 Seconds. Press
SELECT to cancel.
(Scroll Through Sub-Menu Display with CDM Switch)
SCROLL SUB-MENU (Lower Line Only)
#### KNIFE SPEED
##.# HEADER HEIGHT
LOAD|■■■■■■■■■■■■
##.## REEL MPH
##.# DRAPER SPEED
Knife Speed Drops Below Programmed Set-Point.
34
DESCRIPTION
Issue – June 2008