Exhaust System - MacDon M150 2008 Operator's Manual

7.9.9

Exhaust System

CAUTION
To avoid burns, do not touch muffler when
engine is running
sufficient cooling time after shut-down
The exhaust system
maintenance but
periodically as follows:
a. Open engine compartment hood to highest
position.
C
b. Inspect the area around clamps (A) for
breakage, cracks and rust-through. In addition
to excess noise, a leaky exhaust system may
allow exhaust gases to escape to the cab.
c. Dents or crushed portions of any tubing create
exhaust flow restriction and increase back
pressure significantly.
dents will cause decreased fuel economy and
increased turbo wear.
large, increased bearing and cylinder wear will
occur due to increased exhaust temperature.
Form # 169017
MAINTENANCE/SERVICE – M150 ENGINE
or before allowing
requires no regular
it should be inspected
B
A
B
A
Even relatively small
If dents are relatively
d. The exhaust system should be secured to
eliminate vibration. The brackets (B) should fit
securely to the muffler (C) and to the engine.
e. Do not change muffler type, piping sizes or
exhaust configuration; these have all been
selected for some very specific, technical
reasons by the engineer. See your dealer for
proper replacement parts.
140
Issue – June 2008