Table of Contents
Advertisement
H
n. Insert primary filter element (H) into canister
over secondary element and push into place,
ensuring that element is firmly seated in
canister.
F
C
o. Position end cap (F) onto filter housing with duct
(C) pointing approximately as shown.
p. Align arrow (G) to unlock position on end cap
and push end cap fully onto housing.
q. Rotate end cap clockwise until catch (E)
engages housing to prevent end cap from
turning.
r.
Close engine compartment hood.
Form 169017
MAINTENANCE/SERVICE – M200 ENGINE
G
E
149
7.10.5
Aspirator Hose and Check Valve
Replacement
Inspect hose and valve for signs of overheating
that may result if the check valve is not working
properly.
Replace as follows:
a. Remove plastic ties (A) securing hose assembly
(C) to bracket on engine.
B
b. Remove hose clamps (B) securing hose to
muffler and to air cleaner.
assembly.
THIS END
TO EXHAUST
c. Position new hose assembly so that yellow dot
on check valve is on the muffler side.
NOTE
The words "THIS END TO EXHAUST"
appear on the face of the check valve.
C
A
B
Remove hose
(continued next page)
Issue – June 2008
Advertisement
Table of Contents
