Table of Contents
Advertisement
DANGER
Stop engine and remove key from ignition
before leaving operator's seat for any
reason. A child or even a pet could engage
an idling machine.
a. Open engine compartment hood to highest
position.
E
b. Close fuel supply valve (E) under fuel tank.
c. Place a suitable container under the filters.
C
Form # 169017
MAINTENANCE/SERVICE – M200 ENGINE
F
d. Change primary filter (C) as follows:
1. Thoroughly clean around the filter head (F).
G
2. Install a suitable tube onto the water
separator drain (G). Open drain and allow
fluid to drain into the container.
3. Remove the tube and hand tighten drain.
4. If equipped, remove wiring harness from
sensor (H) on bottom of glass bowl (J).
5. Hold glass bowl and remove screw (K).
Remove glass bowl from filter.
6. Remove filter (C) with a filter wrench.
7. Discard filter and seals.
8. Clean seal mating surface on filter head.
9. Do not lubricate O-ring seal and screw the
new filter (C) onto the filter mount until the
gasket contacts the filter head.
10. Tighten the filter an additional ½ to ¾ turn by
hand.
Do not use a filter wrench to install the
filter.
gasket and filter.
11. Install new O-rings onto screw (K) and glass
bowl (J).
12. Locate glass bowl onto filter. Ensure sensor
(if equipped) is in correct position and install
screw. Tighten screw to 44 in-lbf (5 N·m).
152
C
J
IMPORTANT
Over-tightening can damage the
(continued next page)
Issue – June 2008
K
H
Advertisement
Table of Contents
