6.4.2.3
Float Options
For draper headers without the deck shift option,
auger headers, and rotary headers, the float can
be
pre-programmed
windrowing conditions. For example;
•
Position 1 – Border
•
Position 2 – Normal
•
Position 3 – Rocky
Set float pre-sets as follows:
FLOAT
PRESET 1
a. Engage header.
b. Push float preset switch to position 1.
c. Using HEADER TILT SWITCHES, set center
link to mid-range position (05.0 on DISPLAY).
HEADER
TILT DOWN
Form 169017
HEADER – GENERAL
for
three
types
FLOAT
FLOAT
PRESET 2
PRESET 3
DISPLAY
HEADER TILT UP
of
INCREASE
FLOAT LEFT
DECREASE
FLOAT LEFT
d. Using HEADER DOWN switch, lower header
fully with lift cylinders fully retracted.
e. Using left float switch, push
–
or
to decrease float on left side of header.
DISPLAY will indicate selected float for left side,
for example (8.0 L FLOAT R XX.X).
f.
Repeat for right side float with right switch.
DISPLAY will indicate float for both sides, for
example (8.0 L FLOAT R 3.0).
g. Select a second preset with the float preset
switch.
h. Repeat steps e. and f. to set the float.
i.
Select a third preset with the float preset switch.
j.
Repeat steps e. and f. to set the float.
k. Operate windrower.
77
DISPLAY
HEADER DOWN
+
to increase float,
Issue – June 2008
INCREASE
FLOAT RIGHT
DECREASE
FLOAT RIGHT