Table of Contents
Advertisement
HYDRAULIC LINK – M200 STD, M150 OPTION
K
1. Activate header tilt cylinder switch on GSL to
release load on center link cylinder (H).
2. Lift hook release (J) and lift hook (K) off
header pin.
NOTE
If optional center link lift cylinder is
installed, lift release (J) and then operate
the link lift cylinder from the cab to
disengage the center link from the header.
L
h. Disconnect header drive hydraulics (L) and
electrical harness (M). Refer to the R80 Header
Operator's Manual.
i.
Slowly back tractor away from header.
j.
Re-install pins (A) in header boots (B).
Form # 169017
HEADER OPERATION – R SERIES
J
H
M
B
A
104
Issue – June 2008
Advertisement
Table of Contents
