Lubricating The Windrower; Procedure - MacDon M100 2009 Operator's Manual

Self-propelled windrower
Table of Contents

Advertisement

E
d. At the same time pull front end of platform away
from frame while moving it towards the walking
beam. Aft corner (E) of platform should project
slightly into engine bay when optimum opening
is reached.
CAUTION
Do not stand on the platform in the unlocked
position. It is unstable and may result in a
fall.
e. Swing link (D) under platform.
To Close:
C
a. Swing link (D) out from under platform all the
way forward.
b. Move platform front end inboard while moving it
away from the walking beam.
c. Position link (D) on bracket and install bolt and
nut (C). Do not fully tighten.
d. Move platform to closed position, ensuring it is
locked.
e. Close engine compartment hood.
Form # 169304
MAINTENANCE/SERVICE
B
D
96

7.6 LUBRICATING THE WINDROWER

WARNING
To avoid personal injury, before servicing
windrower or opening drive covers, follow
procedures in Section 7.1, Preparation for
Servicing.
Recommend Lubricant
LUBRICANT
SPEC
SAE Multi-
Grease
Purpose.
The greasing points are marked on the machine
by decals showing a grease gun and grease
interval in hours of operation. See illustration
below.
Log
hours
of
"Maintenance Checklist" provided to keep a
record of scheduled maintenance.
Section 7.13, Maintenance Schedule.
7.6.1

Procedure

DANGER
Stop engine and remove key from ignition
before leaving operator's seat for any
reason. A child or even a pet could engage
an idling machine.
a. Wipe grease fitting with a clean cloth before
greasing, to avoid injecting dirt and grit.
b. Inject grease through fitting with grease gun until
grease overflows fitting, except where noted.
c. Leave excess grease on fitting to keep out dirt.
d. Replace
any
loose
immediately.
e. If fitting will not take grease, remove and clean
thoroughly. Also clean lubricant passageway.
Replace fitting if necessary.
DESCRIPTION
USE
High Temp.
Extreme Pressure
(EP2)
As Required
Performance With
Unless
1% Max
Otherwise
Molybdenum
Specified.
Disulphide (NLGI
Grade 2).Lithium
Base
operation
and
use
Refer to
or
broken
fittings
Model Year - 2009
the

Advertisement

Table of Contents
loading

Table of Contents