Table of Contents
Advertisement
DISPLAY WARNINGS AND ALARMS (Continued)
DISPLAY
LOW HYDRAULIC OIL
NO HEADER
NO OPERATOR
NO OPERATOR
ENGINE SHUTDOWN
NOT IN PARK
KNIFE OVERLOAD
PLACE GSL INTO "N"
TRANS OIL PRESS
TRANS OIL TEMP
##.# LOW VOLTS
##.# HIGH VOLTS
Form # 169017
OPERATOR'S STATION
ALARM TONE
Continuous Loud Tone For 5
Seconds. If Condition Not
Rectified, Single Loud Tone Every
5 Minutes
None
Continuous Tone.
Continuous Tone.
Short Beep With Each Flash
Ongoing Intermittent Moderate
Tone Until Condition Is Corrected.
Beeps At 2 Per Second Until
Corrected.
Continuous Loud Tone Until Oil
Pressure Is Regained.
Ongoing Intermittent Moderate
Tone Until Temperature Is Below
Acceptable Level.
Single Loud Tone For 10 Seconds.
Single Loud Tone For 10 Seconds.
40
DESCRIPTION
Low Hydraulic Oil Level. Header
Shuts Down Automatically If
Engaged. Header On Switch Must
Be Moved To OFF Position And
Then To ON Position To Restart The
Header.
Header Is Not Detected.
Operator Not Detected In Seat With
Header Engaged Or Out Of Neutral
Detent.
Engine Shutdown When Operator
Not Detected In Seat With Machine
Moving Under 3 mph (4.8 km/h).
GSL or Interlock Switches Not
Closed With Key On/Engine Off.
Machine Overload. Knife Or Disc
Speed Drops Below Programmed
Value.
GSL or Interlock Switches Not
Closed With Key On/Engine Off.
Low Transmission Charge Oil
Pressure.
Transmission Oil Temperature
Above 221F (100C).
Voltage Below 11.5.
Voltage Above 16.
Issue – June 2008
Advertisement
Table of Contents
