Option Led States - YASKAWA SI-EN3D Technical Manual

Table 4.1 Male 8-way Ethernet Modular Connector (Customer-Supplied)
Male EtherNet 8-Way Modular Connector
*1 Not used for 10 Mbps and 100 Mbps networks.
◆

Option LED States

The option has four LEDs:
• Bi-color Status LEDs:
– Module status (MS) red/green
– Network status (NS) red/green
• Ethernet LEDs:
– Network speed-10/100 yellow
– Link status and network activity-Link/Act green
A - 1000-Series, Z1000U
B - GA500, GA700, GA800
*1 LED label has transparent background and white letters. Please make sure that you use the correct label for Z1000, HV600, or
FP605.
Wait 2 seconds minimum for the power-up diagnostic process to complete before you verify the LED states. The
Table 4.2 shows the operating status of the option LEDs after the power-up diagnostic LED sequence is complete.
Refer to Table 4.3 for more information about the LEDs.
Indication
LED Name
Color
-
Green
Green
MS
Red
Red
Red/Green
-
Green
Green
NS
Red
Red
Red/Green
YASKAWA SIEP C730600 0DB EtherNet/IP Technical Manual
Figure 4.2 Option LED Labels
Table 4.2 Option LED States
Operating State
Display
OFF Power supply off
ON Option operating
Flashing Option initializing
ON Fatal error occurred
Flashing Non-fatal error occurred
Flashing Option self-test
OFF Power supply OFF or Offline
ON Online communications established
Flashing Online communications not established
ON Communications error (fatal)
Flashing Communications time-out (non-fatal)
Flashing Option self-test
Pin
1 (Pair 2)
2 (Pair 2)
3 (Pair 3)
4 (Pair 1)
5 (Pair 1)
6 (Pair 3)
7 (Pair 4)
8 (Pair 4)
C - Z1000, HV600, and FP605
There is no power to the drive.
The option is operating normally.
The option is configuring an IP address.
The option detected a fatal (unrecoverable) error.
The option detected a non-fatal (recoverable) error.
The option is in self-test mode.
-
The option is online and has established connections.
The option is online without an established connection.
The option detected a duplicate IP address.
A communications time-out occurred.
The option is in self-test mode.
4 Option Components
Description
Transmit data (TXD) +
Transmit data (TXD) -
Receive data (RXD) +
*1
Not used
*1
Not used
Receive data (RXD) -
*1
Not used
*1
Not used
*1
Description
13