Procedure D - YASKAWA SI-EN3D Technical Manual

A - Keypad connector tab
B - Keypad connector
C - Drive front cover
Figure 5.19 Install the LED Status Ring board, Front Cover, and Keypad
7.
Set drive parameters in
■

Procedure D

This section shows the procedure to install and wire the option on an HV600 or FP605 drive.
Prepare the Drive for the Option
Before you install the option on an HV600 drive, make sure that the option software version is PRG: 0345 or later.
Before you install the option on an FP605 drive, make sure that the option software version is PRG: 0347 or later.
Correctly wire the drive as specified by the manual packaged with the drive. Make sure that the drive functions
correctly. Refer to the drive manuals for more information.
YASKAWA SIEP C730600 0DB EtherNet/IP Technical Manual
Related Drive Parameters on page 32
D - Keypad
E - LED Status Ring board
for correct option performance.
5 Installation Procedure
25