YASKAWA SI-EN3D Technical Manual page 92

11 Input Assemblies (Converter Produces)
Input Instance Word
6
7
8
9
10
11
Name
Running
During Regenerative Operation
Reset
During Run - Operation Ready
Ready
Alarm
Faulted
oPE
Uv
LOCAL/REMOTE
Multi-Function Digital Output 1
Multi-Function Digital Output 2
Multi-Function Digital Output 3
Output Voltage
92
Byte Bit 7 Bit 6
12 - 13
14 - 15
- -
16
17
18 - 19
20 - 21
22 - 23
Running
0: Stop
1: Running
During Regenerative Operation
0: Converter not in regenerative operation
1: Converter in regenerative operation
Reset
0: -
1: Reset
During Run - Operation Ready
0: Not Ready
1: Ready
Ready
0: Not Ready
1: Ready
Alarm
0: No Alarm
1: Alarm
Faulted
0: No Fault
1: Fault
oPE
0: -
1: oPExx
Undervoltage
0: -
1: Undervoltage
Run command is from network
0: Run command is not from network
1: Run command is from network
Terminal M1/M2 (varies by converter model)
0: M1/M2 OFF
1: M1/M2 ON
This function is enabled only when H2-01 is set to F.
Note:
The names of the digital outputs are different for different converter series.
Terminal M3/M4 (varies by converter model)
0: M3/M4 OFF
1: M3/M4 ON
This function is enabled only when H2-02 is set to F.
Note:
The names of the digital outputs are different for different converter series.
Terminal M5/M6 (varies by converter model)
0: M5/M6 OFF
1: M5/M6 ON
This function is enabled only when H2-03 is set to F.
Note:
The names of the digital outputs are different for different converter series.
Converter Output Voltage
Bit 5 Bit 4 Bit 3
Parameter [F7-37], Default: Terminal A3 Input
Parameter [F7-38], Default: Not Used
- - -
Parameter [F7-39], Default: Not Used (High Byte)
Parameter [F7-40], Default: Converter Software Version
Parameter [F7-41], Default: Not Used
Parameter [F7-42], Default: Not Used
Description
YASKAWA SIEP C730600 0DB EtherNet/IP Technical Manual
Bit 2 Bit 1 Bit 0
Parameter Parameter
[F7-39] (Low [F7-39] (Low
-
Byte), Byte),
Default: Net Default: Net
Ctrl Ref