Option Components; Terminal Block Cn1; Option Led Display - YASKAWA SI-N3 Technical Manual

4

Option Components

◆
Option
A - Connector (CN5)
B - Installation hole
C - LED (MS)
*1
D - LED (NS)
*1
*1 Refer to Option LED Display on page 11
*2 Connect the included ground wire during installation. The ground wire is not necessary for installation on GA700 and GA800 drives.
◆

Terminal block CN1

The communication terminal is a pluggable terminal block that serves as the connection point of the DeviceNet
network communication cable to the option.
Terminal
◆

Option LED Display

The option has two bicolor LEDs:
• Module status (MS)
• Network status (NS)
A - 1000-Series, Z1000U
B - GA500, GA700, and GA800
*1 LED label has transparent background and white letters. Please make sure that you use the correct label for Z1000 or FP605.
Wait 2 seconds minimum for the power-up diagnostic process to complete before you verify the LED states.
The operational status of the option LEDs after the power-up diagnostic LED sequence is complete are described
in Table 4.2.
Refer to Table 4.3 for more information about the LEDs.
YASKAWA SIEP C730600 84F DeviceNet Technical Manual
E - Ground terminal (FE) and installation hole
F - Terminal block CN1
G - Option model number
Figure 4.1 Option
for more information about the LEDs.
Table 4.1 Terminal Descriptions
Pin Color
1 Black
2 Blue
3 -
4 White
5 Red
C - Z1000, FP605
Figure 4.2 Option LED Labels
4 Option Components
Signal
V- Network common
CAN_L CAN data Low
Shield Cable shield
CAN_H CAN data High
Communications network
V+
power DC +24V
*1
*2
Description
11