Procedure B - YASKAWA SI-EN3D Technical Manual

5 Installation Procedure
A - Route wires through the openings provided on
the left side of the front cover.
*1 If there is wiring outside the enclosure, the drive will not meet Enclosed wall-mounted type (IP20/UL Type 1)
requirements.
6.
Firmly connect the Ethernet communication cable to the option modular connector CN1 port 1 or port 2.
Isolate communication cables from main circuit wiring and other electrical and power lines. Make sure that
you firmly connect the cable end. (Refer to
page 30 for more information.
NOTICE
discharge (ESD) procedures. If you do not follow procedures, it can cause ESD damage to the drive circuitry.
7.
Reattach the front cover (A), terminal cover (C), and keypad (B).
Refer to the drive manuals for more information.
NOTICE
erroneous operation.
A - Drive front cover
B - Keypad
8.
Set drive parameters in
■

Procedure B

This section shows the procedure to install and wire the option on a Z1000 drive.
Prepare the Drive for the Option
Correctly wire the drive as specified by the manual packaged with the drive. Make sure that the drive functions
correctly. Refer to the drive manuals for more information.
18
*1
Figure 5.6 Wire Routing Examples
Damage to Equipment. When you touch the option, make sure that you observe correct electrostatic
Do not pinch cables between the front covers and the drive. Failure to comply could cause
Figure 5.7 Replace the Front Cover, Terminal Cover, and Keypad
Related Drive Parameters on page 32
B - Use the open space provided inside the drive to
route option wiring.
Figure 5.28). Refer to Communication Cable Specifications on
C - Drive terminal cover
for correct option performance.
YASKAWA SIEP C730600 0DB EtherNet/IP Technical Manual