Procedure C - YASKAWA SI-EN3D Technical Manual

5 Installation Procedure
A - Drive front cover
7.
Set drive parameters in
■

Procedure C

This section shows the procedure to install and wire the option on a GA700 or GA800 drive.
Prepare the Drive for the Option
Before you install the option on a YASKAWA AC Drive GA700 or GA800, make sure that the option software
version is PRG: 0345 or later.
Correctly wire the drive as specified by the manual packaged with the drive. Make sure that the drive functions
correctly. Refer to the drive manuals for more information.
A - Insertion point for CN5 connector
B - Option
C - Included screws
D - Drive front cover
E - LED label
F - Keypad
Install the Option
Use this procedure to install the option.
22
Figure 5.13 Replace the Front Cover and Keypad
Related Drive Parameters on page 32
Figure 5.14 Drive Components with Option
B - Keypad
for correct option performance.
G - Option modular connector CN1 port 1 (RJ45)
H - Option modular connector CN1 port 2 (RJ45)
I - LED Status Ring board
J - Connector CN5-A
K - Connector CN5-B (Not available for
communication option installation.)
L - Connector CN5-C (Not available for
communication option installation.)
YASKAWA SIEP C730600 0DB EtherNet/IP Technical Manual