YASKAWA SI-EN3D Technical Manual page 29

Note:
Only two screws are necessary to install the option on HV600 and FP605 drives.
A - Option
B - Included screw
6.
Use one of the remaining included screws (B) to connect the ground wire (A) to the ground terminal and
installation hole on the option.
Tighten the screw to a correct tightening torque:
• 0.5 N∙m to 0.6 N∙m (4.4 in∙lb to 5.3 in∙lb)
Note:
Refer to Figure 5.26 for instruction about crimp terminal orientation (C) and wire routing.
A - Ground wire
B - Included screw
YASKAWA SIEP C730600 0DB EtherNet/IP Technical Manual
C - Connector CN5
Figure 5.25 Install the Option
C - Crimp terminal
Figure 5.26 Connect the Ground Wire
5 Installation Procedure
29