YASKAWA SI-EN3D Technical Manual page 64

9 Input Assemblies (Drive Produces)
Input Instance Word
1
2
3
4
5
6
7
8
Name
Running
ZSP
REV Running
Fault Reset
Speed Agree
Ready
Alarm
Faulted
oPE
Uv
LOCAL/REMOTE
Multi-Function Digital Output 1
Multi-Function Digital Output 2
Multi-Function Digital Output 3
64
Byte Bit 7 Bit 6
1 ZSV -
2
3
4 - 5
6 - 7
8 - 9
10 - 11
12 - 13
14 - 15
16 - 17
Running
0: Stop
1: Forward or Reverse Running
Zero Speed
0: Running
1: Stop or DC Injection Braking
Reverse Running
0: Not Reverse Running
1: Reverse Running
Fault Reset
0: -
1: Fault Reset
Speed Agree
0: -
1: Speed actual at speed reference
Ready
0: Not Ready
1: Ready
Alarm
0: No Alarm
1: Alarm
Faulted
0: No Fault
1: Fault
oPE
0: -
1: oPExx
Undervoltage
0: -
1: Undervoltage
Run command is from network
0: Run command is not from network
1: Run command is from network
Terminal M1/M2 (varies by drive model)
0: M1/M2 OFF
1: M1/M2 ON
This function is enabled only when H2-01 is set to F.
Note:
The names of the digital outputs are different for different drive series.
Terminal M3/M4 (varies by drive model)
0: M3/M4 OFF
1: M3/M4 ON
This function is enabled only when H2-02 is set to F.
Note:
The names of the digital outputs are different for different drive series.
Terminal M5/M6 (varies by drive model)
Bit 5 Bit 4 Bit 3
Multi- Multi- Multi-
Function Function Function
Digital Digital Digital
Output 3 Output 2 Output 1
Output Frequency (Low Byte)
Output Frequency (High Byte)
Dynamic Input 1 [F7-33], Default: Fault Code
Dynamic Input 2 [F7-34], Default: Output Power [U1-08]
Dynamic Input 3 [F7-35], Default: Analog Input 2
Dynamic Input 4 [F7-36], Default: Digital Input
Dynamic Input 5 [F7-37], Default: Analog Input 3
Dynamic Input 6 [F7-38], Default: PG 2 Counter
Dynamic Input 7 [F7-39], Default: Net Ref and Net Ctrl
Description
YASKAWA SIEP C730600 0DB EtherNet/IP Technical Manual
Bit 2 Bit 1 Bit 0
LOCAL/
Uv oPE
REMOTE