YASKAWA SI-EN3D Technical Manual page 86
Hide thumbs
Also See for SI-EN3D:
- Technical manual (72 pages) ,
- Installation manual (80 pages) ,
- Installation manual (50 pages)
Table of Contents
Advertisement
11 Input Assemblies (Converter Produces)
Name
LOCAL/REMOTE
Multi-Function Digital Output 1
Multi-Function Digital Output 2
Multi-Function Digital Output 3
Output Voltage
Voltage Command
D1000: Output Current
R1000: -
Terminal A1 Input
Main Circuit DC Voltage
Error Code
F7-33 Alarm Code
D1000: F7-34 Output Power
R1000: F7-34 Not Used
F7-35 Terminal A2 Input
F7-36 Terminal S1 - S12
F7-37 Terminal A3 Input
F7-38 Not Used
F7-39 NetRef (Status)
F7-39 Not Used
F7-40 Converter Software Version
F7-41 Not Used
F7-42 Not Used
Possible extended error codes are listed in
(Register number failure) is usually set.
86
0: -
1: Undervoltage
Run command is from network
0: Run command is not from network
1: Run command is from network
Terminal M1/M2 (varies by converter model)
0: M1/M2 OFF
1: M1/M2 ON
This function is enabled only when H2-01 is set to F.
Note:
The names of the digital outputs are different for different converter series.
Terminal M3/M4 (varies by converter model)
0: M3/M4 OFF
1: M3/M4 ON
This function is enabled only when H2-02 is set to F.
Note:
The names of the digital outputs are different for different converter series.
Terminal M5/M6 (varies by converter model)
0: M5/M6 OFF
1: M5/M6 ON
This function is enabled only when H2-03 is set to F.
Note:
The names of the digital outputs are different for different converter series.
Converter Output Voltage
Converter Voltage Command
D1000: Actual Output Current
Monitors the converter output current.
Unit: 0.01A
Unit is not affected by Current Scale CS.
R1000: -
MEMOBUS/Modbus (0x46)
Monitor parameter U1-13
Main Circuit DC Voltage
Monitor parameter U1-07
U2-01 converted using fault code table.
Programmable: MEMOBUS/Modbus (0x7F)
D1000: Programmable: MEMOBUS/Modbus (0x47)
Monitor parameter U1-08
R1000: -
Programmable: MEMOBUS/Modbus (0x4F)
Monitor parameter U1-14
Programmable: MEMOBUS/Modbus (0x49)
Monitor parameter U1-10
Programmable: MEMOBUS/Modbus (0x50)
-
Voltage command is from network
0: Voltage command is not from network
1: Voltage command is from network
-
Programmable: MEMOBUS/Modbus (0x4D)
Monitor parameter U1-25
-
-
Table 11.1
and
Table
Description
11.2. If an error occurs, extended error code 0x02
YASKAWA SIEP C730600 0DB EtherNet/IP Technical Manual
Advertisement
Table of Contents
