YASKAWA SI-EN3D Technical Manual page 59

Input Instance Word
*1
17
*1
18
*1
19
20
21
*1 Selectable with F7-33 to F7-42.
Name
Running
ZSP
REV Running
Fault Reset
Speed Agree
Ready
Alarm
Faulted
oPE
Uv
LOCAL/REMOTE
Multi-Function Digital Output 1
Multi-Function Digital Output 2
YASKAWA SIEP C730600 0DB EtherNet/IP Technical Manual
Byte Bit 7 Bit 6
*1
33
*1
34
*1
35
*1
36
*1
37
*1
38
*1
39
40 - -
Assy. 116 F7- Assy. 116 F7-
41
30 Error 29 Error
42 - -
Assy. 166 F7- Assy. 166 F7-
43
40 Error 39 Error
Running
0: Stop
1: Forward or Reverse Running
Zero Speed
0: Running
1: Stop or DC Injection Braking
Reverse Running
0: Not Reverse Running
1: Reverse Running
Fault Reset
0: -
1: Fault Reset
Speed Agree
0: -
1: Speed actual at speed reference
Ready
0: Not Ready
1: Ready
Alarm
0: No Alarm
1: Alarm
Faulted
0: No Fault
1: Fault
oPE
0: -
1: oPExx
Undervoltage
0: -
1: Undervoltage
Run command is from network
0: Run command is not from network
1: Run command is from network
Terminal M1/M2 (varies by drive model)
0: M1/M2 OFF
1: M1/M2 ON
This function is enabled only when H2-01 is set to F.
Note:
The names of the digital outputs are different for different drive series.
Terminal M3/M4 (varies by drive model)
0: M3/M4 OFF
1: M3/M4 ON
This function is enabled only when H2-02 is set to F.
9 Input Assemblies (Drive Produces)
Bit 5 Bit 4 Bit 3
Parameter [F7-39], Default: NetRef and NetCtrl (High Byte)
Parameter [F7-40], Default: Drive Software Version (Low Byte)
Parameter [F7-40], Default: Drive Software Version (High Byte)
Parameter [F7-41] (Low Byte), Default: Not Used
Parameter [F7-41] (High Byte), Default: Not Used
Parameter [F7-42] (Low Byte), Default: Not Used
Parameter [F7-42] (High Byte), Default: Not Used
- -
Assy. 116 F7- Assy. 116 F7- Assy. 116 F7-
28 Error 27 Error 26 Error
- -
Assy. 166 F7- Assy. 166 F7- Assy. 166 F7-
38 Error 37 Error 36 Error
Description
Bit 2 Bit 1
Assy. 116 F7-
- -
32 Error
Assy. 116 F7- Assy. 116 F7-
25 Error 24 Error
Assy. 166 F7-
- -
42 Error
Assy. 166 F7- Assy. 166 F7-
35 Error 34 Error
Bit 0
Assy. 116 F7-
31 Error
Assy. 116 F7-
23 Error
Assy. 166 F7-
41 Error
Assy. 166 F7-
33 Error
59