YASKAWA SI-EN3D Technical Manual page 89

Input Instance Word
1
2
3
4
5
Name
Running
During Regenerative Operation
Reset
During Run - Operation Ready
Ready
Alarm
Faulted
oPE
Uv
LOCAL/REMOTE
Multi-Function Digital Output 1
Multi-Function Digital Output 2
Multi-Function Digital Output 3
Output Voltage
F7-33 Alarm Code
YASKAWA SIEP C730600 0DB EtherNet/IP Technical Manual
Byte Bit 7 Bit 6
2
3
4 - 5
6 - 7
8 - 9
10 - 11
Running
0: Stop
1: Running
During Regenerative Operation
0: Converter not in regenerative operation
1: Converter in regenerative operation
Reset
0: -
1: Reset
During Run - Operation Ready
0: Not Ready
1: Ready
Ready
0: Not Ready
1: Ready
Alarm
0: No Alarm
1: Alarm
Faulted
0: No Fault
1: Fault
oPE
0: -
1: oPExx
Undervoltage
0: -
1: Undervoltage
Run command is from network
0: Run command is not from network
1: Run command is from network
Terminal M1/M2 (varies by converter model)
0: M1/M2 OFF
1: M1/M2 ON
This function is enabled only when H2-01 is set to F.
Note:
The names of the digital outputs are different for different converter series.
Terminal M3/M4 (varies by converter model)
0: M3/M4 OFF
1: M3/M4 ON
This function is enabled only when H2-02 is set to F.
Note:
The names of the digital outputs are different for different converter series.
Terminal M5/M6 (varies by converter model)
0: M5/M6 OFF
1: M5/M6 ON
This function is enabled only when H2-03 is set to F.
Note:
The names of the digital outputs are different for different converter series.
Converter Output Voltage
Programmable: MEMOBUS/Modbus (0x7F)
11 Input Assemblies (Converter Produces)
Bit 5 Bit 4 Bit 3
Digital Digital Digital
Output 3 Output 2 Output 1
Output Voltage (Low Byte)
Output Voltage (High Byte)
Parameter [F7-33], Default: Alarm Code
D1000: Parameter [F7-34], Default: Output Power
R1000: Parameter [F7-34], Default: Not Used
Parameter [F7-35], Default: Terminal A2 Input
Parameter [F7-36], Default: Terminal S1 - S8 Input
Description
Bit 2 Bit 1 Bit 0
89