Network Page - YASKAWA SI-EN3D Technical Manual

Network Monitor
O2T API
T2O RPI
T2O API
Consume Message Count
Produce Message Count
Note:
Cumulative counters are reset when the power supply is cycled.
◆

Network Page

The embedded network monitor page shows the status of the option network traffic and open I/O connections.
Network Monitor
Msg Tx OK
Msg Rx OK
Msg Tx Dropped
Msg Rx Dropped
Collisions
Msg Tx Errors
Msg Rx Errors
Tx Retry
Current Connections
IP Address
Subnet Mask
Gateway Address
MAC Address
Address Mode
YASKAWA SIEP C730600 0DB EtherNet/IP Technical Manual
Actual Packet Interval between the originator (PLC) and the target (drive)
Requested Packet Interval between the target (drive) and the originator (PLC)
Actual Packet Interval between the target (drive) and the originator (PLC)
Cumulative number of messages received from the PLC
Cumulative number of messages sent to the PLC
Figure 15.3 Network Page View
Cumulative number of messages transmitted successfully from the option.
Cumulative number of messages received successfully to the option.
Cumulative number of messages dropped due to output network buffer being full and unable to hold the new message.
Cumulative number of messages dropped due to input network buffer being full and unable to hold the new message.
Cumulative number of collisions (half duplex only) reported by the MAC/PHY (Media Access Control/Physical
Connection).
Cumulative number of transmit underruns and transmit stops reported by the MAC/PHY.
Cumulative number of receive overruns, receive stops, and receive error frames reported by the MAC/PHY.
Cumulative number of transmits in which the 1st attempt was delayed due to busy medium reported by the MAC/PHY.
Current number of open connections.
IP Address of the option.
Subnet Mask of the option.
The Gateway IP Address that the option will use.
MAC Address of the option.
Either static IP address or DHCP.
Explanation
Explanation
15 Web Interface
113