Copy/Save - Danfoss VLT AutomationDrive EZ FC 321 Programming Manual

VLT® AutomationDrive EZ FC 321
Programming Guide
Option
[0]
[1]*
[2]
Parameter 0-45 [Drive Bypass] Key on LCP
Table 35: Parameter 0-45 [Drive Bypass] Key on LCP
0-45 [Drive Bypass] Key on LCP
Default value: [1] Enabled
Conversion index: –
Press [Off] and select [0] Disabled to avoid unintended stop of the drive. Press [Off] and select [2] Password to avoid unauthorized
bypass of the drive. If parameter 0-45 [Drive Bypass] Key on LCP is included in the Quick Menu, define the password in parameter 0-65
Personal Menu Password.
Option
[0]
[1]*
[2]

4.1.6 0-5* Copy/Save

Copy parameters from and to the LCP. Use these parameters for saving and copying setups from 1 drive to another.
Parameter 0-50 LCP Copy
Table 36: Parameter 0-50 LCP Copy
0-50 LCP Copy
Default value: [0] No copy
Conversion index: –
This parameter cannot be adjusted while the motor is running.
Option Name
[0]* No copy
[1] All to LCP
[2] All from LCP
[3] Size indep. from LCP
[6] Data from DYN to LCP
[7] Data from LCP to DYN
[10] Delete LCP copy data
50 | Danfoss A/S © 2021.08
Name
Disabled
Enabled
Password
Parameter type: Option
Data type: Uint8
Name
Disabled
Enabled
Password
Parameter type: Option
Data type: Uint8
N O T I C E
Description
Copies all parameters in all set-ups from the drive memory to the LCP memory.
Copies all parameters in all set-ups from the LCP memory to the drive memory.
Copy only the parameters that are independent of the motor size. This selection can be used
to program several drives with the same function without disturbing motor data.
Use to delete the copy after the transfer is complete.
Description
Setup: All setups
Change during operation: True
Description
Disables the key.
Setup: All setups
Change during operation: False
AU373327181955en-000101 / 130R1208
Parameter Descriptions