Danfoss VLT AutomationDrive EZ FC 321 Programming Manual page 223

VLT® AutomationDrive EZ FC 321
Programming Guide
Option Name
[4] Write to setup 1
[5] Write to setup 2
[6] Write to setup 3
[7] Write to setup 4
[8] Cancel BTM transaction
Parameter 8-46 BTM Transaction Status
Table 435: Parameter 8-46 BTM Transaction Status
8-46 BTM Transaction Status
Default value: [0] Off
Conversion index: –
Option Name
[0]* Off
[1] Transaction started
[2] Commit transaction
[3] Transaction timeout
[4] Err. non-existing par.
[5] Err. par. out of range
[6] Transaction failed
[7] SO configu check
[8] SO config check done
Parameter 8-47 BTM Timeout
Table 436: Parameter 8-47 BTM Timeout
8-47 BTM Timeout
Default value: 60 s
Conversion index: 0
Select the BTM timeout after a BTM transaction has been started. Timeout is between each acyclic write of parameters.
Parameter 8-49 BTM Error Log
Table 437: Parameter 8-49 BTM Error Log
8-49 BTM Error Log
Default value: Size related
Conversion index: -3
List of parameters that failed during bulk transfer mode. The value after the decimal break is the fault code (255 stands for no error).
Danfoss A/S © 2021.08
Description
Abort any BTM activity. Parameters are not committed.
Parameter type: Option
Data type: Uint8
Parameter type: Range, 1 - 360 s
Data type: Uint16
Parameter type: Range, 0.000 - 9999.255
Data type: Uint32
Parameter Descriptions
Setup: All setups
Change during operation: True
Description
Setup: 1 setup
Change during operation: False
Setup: 1 setup
Change during operation: True
AU373327181955en-000101 / 130R1208 | 223