Danfoss VLT AutomationDrive EZ FC 321 Programming Manual page 239

VLT® AutomationDrive EZ FC 321
Programming Guide
Option Name
[181] Remote reference
active
[182] Start command
[183] Drive stopped
[185] Drive in hand mode
[186] Drive in auto mode
[187] Start command giv-
en
[190] Digital input X30/2
[191] Digital input X30/3
[192] Digital input X30/4
[193] Digital input X46/1
[194] Digital input X46/3
[195] Digital input X46/5
[196] Digital input X46/7
[197] Digital input X46/9
[198] Digital input X46/11
[199] Digital input X46/13
[249] Therm. sensor temp.
Parameter 13-11 Comparator Operator
Table 456: Parameter 13-11 Comparator Operator
13-11 Comparator Operator
Default Value: Size related
Conversion Index: -
Select the operator to be used in the comparison. This is an array parameter containing comparator operators 0–5.
Option Name
[0] <
≂ (equal)
[1]
[2] >
[5] TRUE longer than..
Danfoss A/S © 2021.08
Description
Active when parameter 3-13 Reference Site is [1] Remote or [0] Linked to hand/auto, while the LCP
is in auto-on mode.
Active when there is an active start command and no stop command.
A stop command (jog, stop, qstop, coast) is issued – and not from the SLC itself.
Active when the drive is in hand-on mode.
Active when the drive is in auto-on mode.
Parameter Type: Option, Array [10]
Data Type: Uint8
Description
The result of the evaluation is true when the variable selected in parameter 13-10 Comparator Op-
erand is smaller than the fixed value in parameter 13-12 Comparator Value. The result is false if the
variable selected in parameter 13-10 Comparator Operand is greater than the fixed value in pa-
rameter 13-12 Comparator Value.
The result of the evaluation is true when the variable selected in parameter 13-10 Comparator Op-
erand is approximately equal to the fixed value in parameter 13-12 Comparator Value.
Inverse logic of option [0] <.
Parameter Descriptions
Setup: 2 set-ups
Change during operation: True
AU373327181955en-000101 / 130R1208 | 239