Danfoss VLT AutomationDrive EZ FC 321 Programming Manual page 370

VLT® AutomationDrive EZ FC 321
Programming Guide
Troubleshooting
5.2.90 ALARM 214, No Sensor Input
Cause
A homing process with a homing function that requires a sensor, or touch probe positioning is started with no input defined for the
sensor.
5.2.91 WARNING/ALARM 215, Start Fwd/Rev
Cause
One of the hardware end-limit options, [12] Enable Start Forward or [13] Enable Start Reverse is active.
5.2.92 WARNING/ALARM 216, Touch Timeout
Cause
A touch probe sensor is not found within the time in parameter 4-75 Touch Timout. The timeout timer is started as soon as the touch
probe positioning is activated even if the application is not moving.
5.2.93 WARNING 220, Configuration File Version not Supported
Cause
The drive does not support the current configuration file version. Customization is aborted.
5.2.94 WARNING 250, New Spare Part
Cause
A component in the drive system has been replaced.
Troubleshooting
• Reset the drive system to restore normal operation.
5.2.95 ALARM 430, PWM Disabled
Cause
The PWM on the power card is disabled.
370 | Danfoss A/S © 2021.08 AU373327181955en-000101 / 130R1208