Method To Set A Specified Address When Using The Rtd - Mitsubishi Electric M32R Series User Manual

Mitsubishi 32-bit risc single-chip microcomputers

Table of Contents

14.3.7 Method to Set a Specified Address when Using the RTD

When using the Real-Time Debugger (RTD), you can set low-order 16-bit addresses of the internal

RAM area. Because the internal RAM area is located in a 48 KB area ranging from H'0080 4000 to

H'0080 FFFF, you can set low-order 16-bit addresses of that area. However, access to any

locations other than the area where the RAM resides is inhibited. Note also that two least significant

address bits, A31 and A30, are always 0's because data are read and written to the internal RAM in

a fixed length of 32 bits.

H'0080 4000~H'0080 FFFF

only can be specified

Figure 14.3.12 Method for Setting Addresses in Real-Time Debugger

REAL-TIME DEBUGGER (RTD)

14.3 Functional Description of the RTD