16.7
Checking method
The following shows the checking methods of the board.
Checking with eyesight
Check the appearance of the device and connection status.
■Checking the installation and wiring
Check if the installation and wiring are performed within the range of the specification.
• Page 157 Checking installation environment
• Page 157 Check the board installation
• Page 157 Checking cables and wiring
■Checking the board appearance
The board status and network status can be checked by MODE LED or switch setting.
• Page 161 Checking LED status
• Page 160 Checking channel numbers
Checking the error
Check the screen displayed on a personal computer.
■Checking with the operating system
The driver operation status can be checked with Device Manager or event viewer.
• Page 158 Checking personal computer and operating system
• Page 158 Checking on Device Manager screen
• Page 159 Checking operations with event viewer
■Checking with the utility
The board status and network status can be checked with the utility.
• Page 160 Checking channel numbers
• Page 160 Checking operations with board diagnostics
• Page 161 Checking operations with tests
• Page 161 Checking LED status
• Checking network status with CC-Link IE Field Network diagnostics: Page 164 Checking network status with CC-Link
IE Field Network diagnostics
• Page 164 Checking network status with monitoring link special relays (SB) and link special registers (SW)
• Page 165 Checking communication status with monitoring access target device
16 TROUBLESHOOTING
156
16.7 Checking method