Mitsubishi Electric M32R Series User Manual page 523

11
(1) ADnSMSL (A-Dn conversion mode selection) bit
This bit selects A-D conversion mode for the A-Dn converter during single mode. Setting this bit
to 0 selects A-D conversion mode, and setting this bit to 1 selects comparator mode.
(2) ADnSSPD (A-Dn conversion rate selection) bit
This bit selects an A-D conversion rate for the A-Dn converter during single mode. Setting this bit
to 0 selects a normal speed, and setting this bit to 1 selects a x2 speed (two times normal speed).
(3) ANsSEL (analog input pin selection) bits (D12-D15)
These bits select analog input pins for the A-Dn converter during single mode. It is the channels
selected by these bits that are operated on for A-D conversion or comparate operation. When
you read these bits, they show the values written to them.
11.2 A-D Converter Related Registers
(D8)
(D9)
11-25
A-D CONVERTERS
Ver.0.10