Mitsubishi Electric M32R Series User Manual page 507

Mitsubishi 32-bit risc single-chip microcomputers

Table of Contents

<8-channel scan>

10-bit A-Di data register

<16-channel scan>

10-bit A-Di data register

Note 1: A-D0 conversion start: Software trigger → Started by setting A-D0 conversion start bit to 1

A-D1 conversion start: Software trigger → Started by setting A-D1 conversion start bit to 1

Note 2: DMA transfer request: Can be generated for only the A-D0 converter.

Figure 11.1.6 Operation of A-D Conversion in Scan Mode (for 8-channel/16-channel Scan)

During continuous scan mode

During continuous scan mode

A-D conversion interrupt request or DMA transfer request (Note 2)

Hardware trigger → Started by output event bus 3 or ADTRG signal input

Hardware trigger → Started by TID1 overflow/underflow or ADTRG signal input

11.1 Outline of A-D Converters

A-D CONVERTERS

Completed here when

operating in single-shot

Completed here when

operating in single-shot

____________