Conta Through: Sequence Output Signal (Reference Value 91); Contb Through: Sequence Output Signal (Reference Value 92); Contc Through: Sequence Output Signal (Reference Value 93); Contd Through: Sequence Output Signal (Reference Value 94) - Fuji Electric Alpha7 VV User Manual

CHAPTER 2 WIRING

CONTa Through: Sequence output signal (Reference value 91)

CONTb Through: Sequence output signal (Reference value 92)

CONTc Through: Sequence output signal (Reference value 93)

CONTd Through: Sequence output signal (Reference value 94)

2

CONTe Through: Sequence output signal (Reference value 95)

This function allows communications input signals to be output via OUT signals of the hardware.
 Function
The signals set to CONT 20 to 24 can be output through OUT signals 1 to 3 of the hardware. When
a CONT□ signal is allocated to an OUT signal, the ON/OFF status of the CONT signal is output
as a through signal to the OUT signal regardless of the function allocation of the corresponding
CONT signal.
CONT signals respectively correspond to CONT a to e
CONTa
CONTb
CONTc
CONTd
CONTe
 Parameter setting
To assign a CONT□ through signal to a sequence output terminal, set the values (91 to 95)
corresponds to the parameter of output terminal function setting. The setting values to the relevant
signals are as follows.
PA3_51 to 53
No.
51
52
53
54
55
2-104
Description of I/O Signals
Corresponding CONT signals
CONT20
CONT21
CONT22
CONT23
CONT24
Name
OUT1 signal assignment
OUT2 signal assignment
OUT3 signal assignment
OUT4 signal assignment
OUT5 signal assignment
Setting range
0 to 95 91 : CONTa through
92 : CONTb through
93 : CONTc through
94 : CONTd through
95 : CONTe through
Change
Power