Electronic Gear Numerator Selection; Sequence Input Signal (Reference Value 24); Sequence Input Signal (Reference Value 25) - Fuji Electric Alpha7 VV User Manual

 Relevant description
(1) Change setting completion
The signal is turned on after the changing process is executed according to the immediate value
change signal, and it is turned off after the immediate value change command is turned off.
(2) Command position / command speed / ABS/INC
Each piece of data can be changed arbitrarily. The immediate value data at the activating edge of
the immediate value change command is enabled. However, the ABS/INC signal retains the state
enabled at the activating edge of the start positioning signal.
(3) Immediate value continuation command
When the immediate value continuation command and the immediate value change command
are turned on simultaneously, priority is given to the immediate value change command.
(4) Positioning cancel / pause
The signal is enabled at an arbitrary timing.
Electronic gear numerator selection 0: Sequence input signal (Reference value 24)
Electronic gear numerator selection 1: Sequence input signal (Reference value 25)
To change the multiplication of the traveling amount of the mechanical system.
 Function
Switch electronic gear numerator 0 or electronic gear numerator 1 to select one of four command
pulse offsets.
The numerator of the electronic gear can be changed through these functions assigned to the
CONT input signal, as shown in the table below.
Electronic gear numerator
selection 1
OFF
OFF
ON
ON
 Parameter setting
To assign numerator 0 of electronic gear or numerator 1 of electronic gear to a sequence input
terminal, specify the corresponding value ("24" or "25") to the input terminal function setting
parameter.
This signal is handled to be always turned off if it is not assigned to the sequence input terminal.
Electronic gear numerator
selection 0
OFF
ON
OFF
ON
CHAPTER 2 WIRING
Enabled electronic gear numerator selection
PA1_6: Numerator 0 of electronic gear
PA2_51: Numerator 1 of electronic gear
PA2_52: Numerator 2 of electronic gear
PA2_53: Numerator 3 of electronic gear
Description of I/O Signals
2
2-51