Encoder Cable With Battery Fabrication Method - Fuji Electric Alpha7 VV User Manual

CHAPTER 2 WIRING
[2] Solder the wiring to the connector.
Fitting a shrinkable tube to each wire
ensures safety.
[3] Fit the shell body to the connector.
2
[4] Align the shell cover with the clips on
both sides of the shell body and attach.
[5] Fit the cable clamp to the assembled shell,
and secure with the screws.
[6] Secure by aligning the clip with
the mold cover.
2.4.2.2

Encoder Cable With Battery Fabrication Method

GYS model 0.75kW or less/GYB model lead wire specification
Servo amplifier side
GYB model connector connection specification
Servo amplifier side
There is no need to connect the shielded end of
the motor side connector.
[1] Peel off approximately 32 mm from the end of the
shielded wire.
[2] Peel off approximately 3 mm from the end of the core
wire.
Cut the braided wire approximately in half.
2-24
Encoder
Clip
Connect the shielded end of the connector at the motor side
to pin No. 3.
Relay the shielded wire with a lead wire of AWG #22 to #26.
and then crimp it to the connector pin.
Motor side
WSB-BC kit
Motor side
WSB-BC kit