Brake Connector - Fuji Electric Alpha7 VV User Manual

CHAPTER 2 WIRING

2.3.2 Brake Connector

Connector kit type:
WSK-M02P-E (GYS model: 0.75kW or less/GYB model: lead wire specification servomotor side)
2
Connector terminal symbol
The brake of the servomotor equipped with a brake is a non-exciting brake. To turn the servomotor,
+24 [V] must be supplied. There is no polarity in the brake input circuit.
If the brake is left released, although the periphery of the brake becomes hot it is not a fault.
Use a relay or solid state relay (SSR) as the brake cannot be released directly in the sequence output
terminal (DC+30V/50mA).
The GYS model 1.0 to 1.5kW brake terminal is located inside the WSK-M06P-CA motor power
connector, and the GYG model 1.0 to 1.5kW brake terminal is located inside the WSK-M06P-CC motor
power connector.
Attach and tighten the connector at the GYB motor side using the screws provided (tightening torque:
0.2 N∙m).
Connected to
encoder cable.
2-20
Servomotor
1 Br
2 Br
Connected to power
supply (+24V).
Connected to motor power cable.