Acc0: Sequence Input Signal (Reference Value 14) - Fuji Electric Alpha7 VV User Manual

ACC0: Sequence input signal (Reference value 14)

ACC0 switches the acceleration/deceleration time.
 Function
(1) Acceleration/deceleration time switch
The acceleration time and deceleration time of the servomotor follow the setting of PA1_37 to 40
(acceleration time, deceleration time). The acceleration time and deceleration time can be set
separately.
The setting through ON/OFF of the ACC0 signal despite the direction of rotation, as shown in the
table below can be switched.
ACC0 Acceleration time
OFF
ON
 Parameter setting
To assign the ACC0 (acceleration/deceleration time selection) signal to a sequence input terminal,
specify the corresponding value ("14") to the input terminal function setting parameter. This signal
is handled to be always turned off if it is not assigned.
Deceleration time
PA1_37 PA1_38
PA1_39 PA1_40
CHAPTER 2 WIRING
Description of I/O Signals
2
2-43