Pa2_36 To 39 Override Settings; Pa2_40 Internal Positioning Data Selection - Fuji Electric Alpha7 VV User Manual

CHAPTER 4 PARAMETER

PA2_36 to 39 Override settings

No.
36 Override 1
37 Override 2
38 Override 4
39 Override 8
These parameters are enabled under speed and position control.
To use these signals, be sure to turn on "override enable."
With this setting, the speed can be changed during operation. For the weight of the override, refer to
4
the table below.

PA2_40 Internal positioning data selection

No.
Internal positioning data
40
selection
Select whether the internal positioning data is enabled or disabled.
For the immediate data start, setting the address FFH is not necessary when the parameter is set to
"0".
When set to "1", it is necessary to set the address FFH.
4-80
Automatic Operation Setting Parameters
Name
0 [%] to 150 [%]
Ratio of override
Override Override Override
8 4 2
OFF OFF OFF
OFF OFF OFF
OFF OFF ON
OFF OFF ON
OFF ON OFF
OFF ON OFF
OFF ON ON
OFF ON ON
ON OFF OFF
ON OFF OFF
ON OFF ON
ON OFF ON
ON ON OFF
ON ON OFF
ON ON ON
ON ON ON
* For default override weight
Name
0: Disable
Setting range
Traveling
Override
speed
1
%
OFF 0
ON 10
OFF 20
ON 30
OFF 40
ON 50
OFF 60
ON 70
OFF 80
ON 90
OFF 100
ON 110
OFF 120
ON 130
OFF 140
ON 150
Setting range
1: Enable
Default
Change
value
10 Always
20 Always
40 Always
80 Always
Default
Change
value
0 Power