Connection Example To Host Controller - Fuji Electric Alpha7 VV User Manual

2.6 Connection Example to Host Controller

For products not described in this manual, be sure to refer to the manual attached to the corresponding
product. Refer to the connection diagram described here.
 Connector 4 (CN4) is for the PC Loader. It is irrelevant to operation or stopping of the servomotor.
 To drive a servomotor, the main power and control power must be supplied. To edit parameters or
perform similar operation without rotating the motor, supply only the control power.
 Prepare separate power supplies for 24 [V] DC sequence I/O (CN1) and 24 [V] DC brake.
This is to isolate the effects of voltage fluctuation caused by counter electromotive force generated
by power-on and -off of the brake coil. There is no polarity in the brake power supply input.
 Connector 5 (CN5) connection is used for linear scale feedback, or for wiring the DD motor
(scheduled for support in near future).
 The connector 6 (CN6) connection is a safety terminal. Wire if necessary. Refer to "2.7 Safety
Function" for details.
CHAPTER 2 WIRING
Connection Example to Host Controller
2
2-105