Analog Monitor Output (Mon1, Mon2, M5); Sequence Input (Cont1, Cont2, Cont3 - Fuji Electric Alpha7 VV User Manual

2.1.3.5

Analog Monitor Output (MON1, MON2, M5)

The analog monitor output is the analog voltage output terminal of the servo amplifier. The output is
specified with a parameter.
Observe after 2 seconds or longer have elapsed since turning ON the power.
The output voltage will be unstable immediately after turning ON the power, and after turning OFF the
power.
 Max. ±10 [V]/0.5 [mA]
 Resolution: 14-bit/± full scale
2.1.3.6 Sequence Input (CONT1, CONT2, CONT3, ... COMIN)
These are input terminals for sequence control.
 They are compatible with both sink input and source input.
 Use in the 12 to 24 VDC range.
 Approximately 8[mA] (for 24 VDC) is consumed per point.
 Terminal functions are set with parameters.
Refer to "2.5.3 Signal Descriptions" onward for details on assignable signals.
COMI N
DC12 ～ 24V
CONT n
Servo amplifier
(Sink input)
MON1
MON2
Servo amplifier
サーボアンプ
M5
0V
3k
CHAPTER 2 WIRING
COMI N
3k
DC12 ～ 24V
CONTn
Servo amplifier
(Source input)
Configuration
2
2-15