Power Steering Unit Installation - Polaris GENERAL 2016 Service Manual

STEERING / SUSPENSION

POWER STEERING UNIT INSTALLATION

1. If the power steering unit was removed from the
mount bracket, reinstall it prior to vehicle installation.
Torque the mounting bolts to specification.
TORQUE
Power Steering Unit Fasteners:
30 lb-ft (41 Nm)
2. Install the power steering unit into the vehicle and
align the skip-tooth spline on the power steering stub
shaft with the opening in the lower steering shaft.
8.12
3. Place the power steering mount bracket over the top
of the brake pedal mount studs and finger tighten the
four nuts.
4. Position the lower steering shaft on the power
steering unit stub shaft and install the pinch bolt.
Torque to specification.
TORQUE
Lower Steering Shaft to Power Steering Pinch Bolt:
30 lb-ft (41 Nm)
5. Torque mount bracket fasteners to specification.
TORQUE
Power Steering Unit Mount Fasteners:
18 lb-ft (24 Nm)
9929375 R02 - 2016-2019 GENERAL / GENERAL 4 Service Manual
© Copyright Polaris Industries Inc.