Polaris GENERAL 2016 Service Manual page 273

11. Mark the location of the upper shift cable jam nut (N).
Loosen the lower jam nut (P) and remove the shift
cable assembly from the bracket (Q).
12. Relieve pressure from the fuel rail. Disconnect the
fuel line at the fuel rail wrap the ends with a clean rag
to assure no dirt gets in the fuel system.
13. Using a 13mm socket and wrench, remove the
fastener (R) securing the bottom of the intake plenum
to the rear transmission mount.
9929375 R02 - 2016-2019 GENERAL / GENERAL 4 Service Manual
© Copyright Polaris Industries Inc.
14. Using a long screwdriver, loosen both hose clamps
(S) that retain the intake plenum runners to the
cylinder head intake adapters. Remove the intake
plenum and electronic throttle control as an
assembly.
15. Use an overhead or portable hoist to support the
transmission by securing a strap (T) through the rear
mount.
NOTICE
Place a spacer or support between the vehicle frame
and engine to hold the engine up in position while
removing the transmission to engine mounting bolts.
TRANSMISSION
6
6.11