Polaris GENERAL 2016 Service Manual page 538

BODY / FRAME
8. While pushing the door upward and inward, tighten
the four 13mm door hinge fasteners
TORQUE
Door Hinge Fasteners: 27 lb-ft (37 Nm).
9. Check the front door gap on its leading edge.
NOTICE
If door gap adjustment is needed, make a small
adjustment to the striker pin vertical position and redo
steps 2,7, and 8.
10. Verify the door properly opens, closes, and locks.
11. Install plastic door panel covers.
10.60
t
. Rear Door Alignment
1. Loosen 13mm hinge fasteners
2. Remove
3. Close door and guide door latch into striker.
4. Ensure the door is fully locked
9929375 R02 - 2016-2019 GENERAL / GENERAL 4 Service Manual
hinge fasteners
packaging clip.
q
.
and remove plastic
© Copyright Polaris Industries Inc.