Digital Wrench® Communication Errors; Digital Wrench Diagnostic Connector; Digital Wrench® Serial Number Location - Polaris GENERAL 2016 Service Manual

Table of Contents

DIGITAL WRENCH® COMMUNICATION

If you experience problems connecting to a vehicle or

any Digital Wrench® related problem, visit the Digital

Wrench® Knowledge Base for the most current

troubleshooting information, FAQs, downloads and

software updates at: http://polaris.diagsys.com/.

9929375 R02 - 2016-2019 GENERAL / GENERAL 4 Service Manual

DIGITAL WRENCH DIAGNOSTIC

The diagnostic connector is located under the passenger

seat connected to a sealed plug. To access the

diagnostic connector on 2 seat models with a center

console the center console must be removed.

Follow these steps to connect the diagnostic interface

cable to the vehicle to allow Digital Wrench® use:

1. Assemble the SmartLink Module and attach the PC

Interface Cable to your laptop. Refer to "Special

Tools - Electrical System"page 11.21.

2. Remove the protective cap from the Digital Wrench®

3. Connect the Vehicle Interface Cable to the Digital

Wrench® diagnostic connector.

4. Turn the ignition key to the 'ON' position, select the

appropriate vehicle and wait for the status to display

'Connected' in the lower left corner of the screen.

DIGITAL WRENCH® SERIAL NUMBER

Open the configuration screen by clicking on the wrench

icon. The serial number is located on the right side of the

Chapters

Table of Contents