U-Joint Disassembly - Polaris GENERAL 2016 Service Manual

U-JOINT DISASSEMBLY

NOTICE
Before servicing the prop shaft U-joint, be sure the joint
is clean to ensure no debris damages the yoke.
1. With the prop shaft removed and marked for
alignment orientation, remove the retaining rings
from both sides of the yoke.
2. Using a commercially available Ball Joint / U-Joint
Press Set, place a receiving cup adapter
larger ID than the U-joint cap OD on one end.
3. Place a remover adapter
with a smaller OD than the U-joint cap.
9929375 R02 - 2016-2019 GENERAL / GENERAL 4 Service Manual
© Copyright Polaris Industries Inc.
q
w
with a
e
on other end of U-joint
r
4. Position clamp over receiving cup adapter and
remover adapter.
5. Tighten clamp with hand tools to force U-joint cups
out of yoke.
6. Discard and replace all U-joint parts that were
removed from the yoke.
FINAL DRIVE
7
7.19