Polaris GENERAL 2016 Service Manual page 145

7. Using a dial bore gauge, measure big end I.D. in two
directions shown. Record
compare to specifications.
8. Refer to the number stamped onto the exhaust side
of the connecting rod. This number represents the
bore diameter.
9. The table below lists the big end bore diameter
specifications.
Bearing Selection Chart — Rod Bearings
CONNECTING ROD BIG END BORE
DIAMETERS
1 2
1.7318 - 1.7321 -
1.7321" 1.7323"
(43.989 - (43.996 -
43.996 mm) 44.003 mm)
10. Whether using new connecting rods or re-installing
the original ones, refer to the bearing selection chart
provided in the Connecting
Selectionpage 3.61 procedure.
9929375 R02 - 2016-2019 GENERAL / GENERAL 4 Service Manual
© Copyright Polaris Industries Inc.
measurements and
3
1.7323 -
1.7326"
(44.003 -
44.010 mm)
Rod Bearing
ENGINE / COOLING SYSTEM
3
3.59