Polaris GENERAL 2016 Service Manual page 465

e
3. Torque the banjo bolt to specification.
TORQUE
Brake Line Banjo Bolts:
15 lb-ft (20 Nm)
4. Install the adjustment set screw and turn clockwise
until stationary pad contacts disc, then back off 1/2
turn (counterclockwise).
5. Bleed the brake system. Refer to "Brake Bleeding /
Fluid Change"page 9.35 procedure.
6. Install front wheels.
Installation"page procedure.
7. Field test unit for proper braking action before putting
into service. Inspect for fluid leaks and firm brakes.
Make sure the brake is not dragging when pedal is
released. If the brake drags, re-check assembly and
installation.
NOTICE
If new pads are installed, refer to "Brake Burnishing
Procedure"page 9.36.
9929375 R02 - 2016-2019 GENERAL / GENERAL 4 Service Manual
© Copyright Polaris Industries Inc.
Refer to "Wheel
BRAKE SYSTEM
9
9.45