Engine / Chassis Electrical Ground; Spark Plug Service - Polaris GENERAL 2016 Service Manual

Table of Contents

2. Coat the terminals with dielectric grease.

3. Connect and tighten the red (+)

4. Connect and tighten the black (-)

5. Verify that cables are properly routed and reinstall the

driver's seat.

ENGINE / CHASSIS ELECTRICAL GROUND

Inspect the ground cable connections. Remove ground

terminals and clean if necessary.

1. The chassis ground connection

start solenoid

, can be accessed through the left

rear wheel area.

2. Inspect the chassis ground terminals. Be sure the

grounds are clean and tight.

9929375 R02 - 2016-2019 GENERAL / GENERAL 4 Service Manual

cable first.

A hot engine can cause serious burns. Allow engine to

cool or wear protective gloves when removing the spark

Inspect and replace the spark plugs at the intervals

outlined in the Periodic Maintenance Chart.

1. Lift the cargo box.

2. Remove both spark plug caps

, located below the

Note MAG and PTO reference decals on spark plug

3. Clean out plug wells with compressed air to remove

any loose dirt or debris.

4. Rinse plug wells with water and dry with compressed

Spark plug wells have drain holes built into the cylinder

5. Remove spark plugs using spark plug socket with an

wires for reassembly.

head to allow water to drain out.

Table of Contents