Polaris GENERAL 2016 Service Manual page 256

PVT SYSTEM
4. If removed, install the rollers
u
clips onto the spider.
5. Install the spring so the arm
the moveable sheave.
o
6. Align the X's on the spider and moveable sheave.
5.30
t y
, washers and E-
i
rests into the notch in
7. Install the universal clutch compressor on the clutch
and compress the helix cover.
CAUTION
The helix cover is loaded by the spring. Not using a
proper compressor may result in personal injury or
damage to the clutch.
8. Align the marks previously made on the helix cover
and moveable sheave. Install the helix/cover and the
a
four fasteners . Torque fasteners to specification.
TORQUE
Helix Retaining Screws:
48 in-lb (5 Nm)
9. Once back together, verify the grease / tape marks
made during disassembly are properly aligned.
10. Install the drive clutch on the vehicle. See PVT
Assemblypage
9929375 R02 - 2016-2019 GENERAL / GENERAL 4 Service Manual
© Copyright Polaris Industries Inc.