Driven Clutch Service (Intl); Driven Clutch Slider Inspection; Pvt System; Driven Clutch Disassembly - Polaris GENERAL 2016 Service Manual

Table of Contents

DRIVEN CLUTCH SERVICE (INTL)

The square sliders can be inspected with the driven

clutch installed on the vehicle.

Using a feeler gauge, measure the distance between the

slider and the stationary sheave at the widest point

the measurement is over the service limit, the sliders or

driven clutch will need to be replaced. Also measure the

width of the slider block

. Replace the sliders if they are

smaller than the service limit.

Slider to Sheave Clearance

Service Limit: 0.175" (4.5 mm)

Slider Width

Service Limit: 0.975" (24.8 mm)

9929375 R02 - 2016-2019 GENERAL / GENERAL 4 Service Manual

1. Remove driven clutch from the transmission input

2. It is important to mark the position of the helix cover,

3. Place the driven clutch (helix side up) into the

sheaves and spider with a tape or grease marker (as

shown) before disassembly. Some components will

have X's on the components for alignment reference.

This helps with clutch assembly and maintains clutch

Universal Clutch Compressor.

Universal Clutch Compressor: PU-50518-A

Table of Contents