Polaris GENERAL 2016 Service Manual page 252

PVT SYSTEM
8. Tighten the spider jam nut using Clutch Spider Nut
d
Socket . Torque jam nut to specification.
Clutch Spider Nut Socket: PU-50578
TORQUE
Spider Jam Nut:
250 ft-lb (339 Nm)(Apply 0.1 mL Loctite® 7088
Primer and 0.1 mL Loctite® 620™) in 90° apart to the
threads of the spider jam nut.
9. After the spider and jamb nut have been torqued,
remove the clutch assembly from the holding fixture
and inspect the alignment marks made during
disassembly.
NOTICE
If the marks illustrated below are not in alignment upon
assembly, the clutch will not be in balance and the drive
clutch assembly must be replaced.
10. Install the limiter spacer
CAUTION
DO NOT reassemble the drive clutch without the limiter
spacer. Belt life will be greatly reduced.
5.26
f g
and the clutch spring
11. Install the drive clutch cover
in alignment.
12. Install cover bolts
evenly to specification.
Drive Clutch Cover Bolts:
.
9929375 R02 - 2016-2019 GENERAL / GENERAL 4 Service Manual
h
. Be sure all marks are
j
and torque in a cross pattern
TORQUE
9 ft-lb (12 Nm)
© Copyright Polaris Industries Inc.