Power Steering Unit Removal; Power Steering Unit Installation - Polaris RANGER 500 2017 Service Manual

POWER STEERING UNIT REMOVAL

1. Remove upper steering shaft and steering wheel
(See Steering Wheel / Upper Steering Shaft
Removal (EPS) page 9.10).
2. Using a 15 mm socket, remove the fastener
q
retaining the lower steering shaft to the power
steering unit.
3. Remove the four fasteners
steering mount to the power steering unit.
WARNING
Electronic Power Steering (EPS) units are not
interchangeable between ATV and RANGER product
lines.
9850043 R01 - 2017-2021 RANGER 500 / 570 Service Manual
© Copyright Polaris Inc.

POWER STEERING UNIT INSTALLATION

1. Install the power steering unit onto the mount bracket
2. Align the skip-tooth spline on the power steering
3. Install power steering to mount assembly and torque
4. Install the pinch bolt retaining the lower power
w
retaining the power
5. Position the steering wheel, pivot tube and upper
6. Be sure the front wheels are pointing straight ahead
STEERING / SUSPENSION
and torque power steering mounting bolts to
specification.
TORQUE
EPS Unit Mount Bolts:
30 lb-ft (41 Nm)
output shaft with the opening in the lower power
steering shaft.
fasteners to specification.
TORQUE
EPS Unit Frame Bolts:
14 lb-ft (19 Nm)
steering shaft to the power steering unit. Torque to
specification.
TORQUE
EPS Unit Pinch Bolts:
15 lb-ft (20 Nm)
steering shaft assembly to the proper mounting
location.
and that the steering wheel is straight. Align the skip-
q
tooth spline on the power steering input shaft with
w
the opening in the upper steering shaft and install
the upper shaft onto the power steering input shaft.
9
9.11