Power Steering Unit Removal; Power Steering Unit Installation - Polaris RANGER XP 900 2018-2019 Service Manual

POWER STEERING UNIT REMOVAL

1. Remove upper steering shaft and steering wheel.
Refer to "Steering Wheel / Upper Steering Shaft
Removal (EPS)"page 8.7 procedure.
2. Using a 15 mm socket, remove the fastener retaining
the lower steering shaft to the power steering unit.
3. Secure the power steering unit and remove the
fasteners (W) retaining the power steering mount to
the frame.
4. Remove the three fasteners retaining the power
steering mount to the power steering unit.
CAUTION
Electronic Power Steering (EPS) units are NOT
interchangeable between ATV and RANGER product
lines.
9929399 R01 - 2018-2019 RANGER XP/ CREW 900/1000 Service Manual
© Copyright Polaris Industries Inc.
STEERING / SUSPENSION

POWER STEERING UNIT INSTALLATION

1. Install the power steering unit onto the mount bracket
and torque power steering mounting bolts to
specification.
TORQUE
EPS Unit Mount Bolts:
30 lb-ft (41 Nm)
2. Align the skip-tooth spline on the power steering
output shaft with the opening in the lower power
steering shaft.
3. Install power steering and mount assembly to the
frame and torque fasteners to specification.
TORQUE
EPS Unit Frame Bolts:
14 lb-ft (19 Nm)
4. Install the pinch bolt retaining the lower power
steering shaft to the power steering unit. Torque to
specification.
TORQUE
EPS Unit Pinch Bolts:
15 lb-ft (20 Nm)
5. Position the steering wheel, pivot tube and upper
steering shaft assembly to the proper mounting
location.
6. Be sure the front wheels are pointing straight ahead
and that the steering wheel is straight. Align the skip-
tooth spline on the power steering input shaft with
the opening in the upper steering shaft and install the
upper shaft onto the power steering input shaft.
8
8.9