Polaris GENERAL 2016 Service Manual page 350

FINAL DRIVE
6. Disconnect contactor connector.
7. Remove the lower fastener on the passenger front
shock.
8. Remove Winch from passenger side.
9. Remove winch mounting plate from frame by
removing four 15mm nuts
10. Remove both front drive shafts from the front
gearcase. Refer
Removal"page procedure.
11. Remove Skid plate.
7.48
w
.
to "Front Drive
12. Remove two 15mm fasteners
bearing.
13. Without removing the front propshaft from the support
bearing, slide the assembly rearward to disengage
the front propshaft from the gearcase input shaft.
14. Disconnect the wire harness for the front gearcase
and remove the harness from the retaining dart.
15. Remove the vent line from the front gearcase and
Shaft
plug vent line fitting.
16. Remove the four fasteners
gearcase to the frame.
9929375 R02 - 2016-2019 GENERAL / GENERAL 4 Service Manual
e
securing support
r
securing the front
© Copyright Polaris Industries Inc.